Огромная благодарность Автору Kaye Hartman за Мастер-класс
Gumpaste #24 or #26 floral wire
Edible glue
Long-nosed pliers
4mm or #3 round piping tip
Small daisy cutter
Small ball tool
Dresden tool
Make a ball of green gumpaste the size of a macadamia nut or use a measuring ruler to make uniform balls
Use #24 or #26 floral wire and bend an open hook using a long-nosed plier.
Brush a small amount of edible glue on the floral wire and insert the hooked wire into the center of the ball about halfway through.
Indent a small circle in the middle of the ball using a 4mm or #3 round piping tip.
Poke holes around the circle using a needle tool and let dry for at least a couple of hours.
Using a small daisy cutter, cut a set of petals and detach each from the
center.
Use a small ball tool to thin and elongate each of the detached daisy petals.
Run a dresden tool through the center of each petal to make an indentation and curl the petals inward
Brush a small amount of edible glue on the petals and attach around the center of the flower.
This is how the first layer of small petals should look.